Guide · reviewed November 14, 2026
Print dollhouse wallpaper at the correct size
Check the ruler, disable page scaling, and join tiled sheets without changing the repeat.
Open Miniature Print Workshop →Measure the model first
Measure the actual miniature wall between the points you intend to cover. A wall that is 250 mm wide in the model should be entered as 250 mm in Miniature dimensions mode. Choosing 1:12 sets the size of the pattern motifs; it does not divide that wall by twelve again. If you are starting from an imagined full-size room, switch to Full-size room dimensions and enter centimeters instead. A 300 cm wall at 1:12 becomes 250 mm.
Print one sheet before the set
Download the PDF for your actual paper size. In the print dialog, choose Actual size or 100% rather than Fit. Adobe documents that Fit can enlarge or reduce a page. Measure the 50 mm test bar with a physical ruler. If it is not 50 mm, fix the printer scaling before printing the remaining sheets. A correct screen preview cannot verify the size produced by your printer.
Join the paper before cutting the final wall
Sheets are numbered by row and column. Adjacent pages share 10 mm of the same design. Overlay matching motifs, trim one overlapping edge, and align the repeated content rather than placing the sheet edges directly against each other. Test the assembled paper against the wall and mark corners before applying adhesive. Keep spare matching paper for a damaged corner or a later repair.